Since September 2011, we have been holding training sessions once every two months under the guidance of Prof. Emeritus of Osaka University / Prof. Nogi, who we are conducting joint research with.

In the last session, we had a lecture on th...

Our LASER welding system is consisted of the combination of Rofin’s 2kW fiber LASER, KUKA’s 6-axis robot, and a 3-meter linear unit as the robot’s traveling axis, achieving high-precision repeat position accuracy over a wide range o...

The other day, a “Welding AI Robot” was newly installed in Factory A-3  [Welding / Assembly facility]. As the future strategy, we will work hard for improvement of the production capacity of manufacturing sites in collaboration with Mr...

The “Welding AI robot” was newly installed into the A-3 Welding / Assembly Facility. In the very near future, we are sure that we will work together with robots as new “members” to improve the production capacity at manufactu...

Prior to introducing the latest alloy analyzer, the operating training and relevant demonstration were performed by its manufacture. An alloy analyzer is a device that irradiates a metal with X-rays, measures and analyzes the energy unique to each...

At the end of last October, we shipped the highest-level products we have shipped this year. Expansion Joints for connectible condensers for overseas plants. 9m X 9m, gross weight 9t....

Is this the genuine domestic product, the “Strengthened Epsilon Rocket” which JAXA (Japan Aerospace Exploration Agency) successfully carried out engine combustion tests on December 21 last year? Even newer technology than previously used, along with ...

Is everyone aware of J-PARC? J-PARC (Japan Proton Accelerator Research Complex) is located in Tokai in Ibaraki Prefecture, and is jointly operated by the Japan Atomic Energy Agency (JAEA), and the High Energy Accelerator Research Organization (KEK)....

Using Neutron Japan’s “Super Hulk,” the world’s largest hydroforming device at 50,000kN/m, we carried out a water-pressure test on bellows (diameter 1,800mm X length 1,000mm) which were used in the dam diffuser Expansion Joints.   Without ...

We performed the following types of tests at our plant. （＊Desighn Test Code:EJMA） – Fatigue Testing – Buckling Test – Yield and Rupture Test ◎Model Type 1: Diameter DN850, Plate Thickness t1.2, Material Quality SUS316 Typ...